Redfluid single ring fittings are designed according to the Deutsches Institut fϋr Normung DIN 2353 / ISO 8434-1 standard. They are used to join pipes and tubing in hydraulic systems.
These accessories can withstand up to 800 bar depending on the series they are and the diameter of the pipe. They come in different sizes (from 4 to 42 mm OD) depending on the diameter of the tubing or tube that must be connected with it.
There are all forms, from straight fittings, crosses, Tees, Elbows, Mixed, Male or Female thread x Ring, bushings, to weld, etc. Regarding materials, they are manufactured as standard in 316 Stainless Steel or Carbon Steel.
Do you need more info? Here you can download the technical datasheet of this product.
Different series depending on the service pressure required, from 100 bar to 800 bar from -60ºC to 400ºC.
For tubing in external diameter measurements from 4 mm to 42 mm OD. For inch measurements, you’ll need to use double ring fittings.
NPT (ANSI / ASME B1.20.1), BSPP or Cylindrical GAS Whitworth type B, Metric Parallel, type B, UNF, BSPT Taper)
Carbon Steel, 316 / 316L Stainless Steel, or 316 + Ti.
Optionally they can be supplied with an interior silver bath on the nuts to prevent them from seizing.
If you need other connections, materials, figures or other modifications, we can tailor it for you. Place your order here.
 |
 |
 |
 |
| Straight Fittings | Cable gland | Lateral Male Tees | Plugs |
 |
 |
 |
 |
| Elbows | Straight x Male Thread | Smooth spigot | Reinforcing |
 |
 |
 |
 |
| Tees | Elbows x Male Thread | Pre-assembled Fittings | Gasket |
 |
 |
 |
 |
| Crosses | Central Male Tees | Straight Fittings x Threaded Female | Nuts and Rings |
You will never have leakage problems again once you start using these accessories because they ensure a tight seal between two pipes, so there is no possibility of liquid escaping during operation!
EN 10204 2.2 o 3.1
Do you need more info?
If you wish, you can also contact us to ask for more information or place an order:
RedFluid®
